Written by
Maya Ortiz Appliance Repair Content SpecialistPublished October 20, 2026
Whirlpool®
Code overviewat a glance.
The facts for this Whirlpool error, a plain-language snapshot, and what to confirm against your model number.
FCE1
Error codeFCE1
ApplianceMicrowave
Quick answer
FCE1 means the appliance could not connect to the router. Reset power, reset the wireless router and check signal strength.
Model note: Whirlpool reuses codes across series and model years, so FCE1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Whirlpool®
What this codemay mean.
A plain-language reading of the code — always confirm against your model’s documentation.
Mean
The appliance could not connect to the router.
FCE1 is a connection message rather than a cooking fault: the appliance could not connect to the router. Among the manual’s possible causes are a time out while connecting, a weak signal, a router that has failed, the appliance’s own Wi-Fi Module, and wiring. It is documented for over-the-range microwaves and ranges.
Power the appliance down and up
Switch the circuit breaker off for one minute, switch it on, then monitor the appliance for one minute to make sure FCE1 does not display again. Verify appliance operation. Unplugging for the same minute is the alternative.
Reset the wireless router
The manual describes the problem as no link between the Wi-Fi Module and the wireless router. Reset your router, then see whether other Wi-Fi devices behave. If your smartphone or tablet works, carry it to the appliance and test it there. When it does, disconnect power from the router for 2 minutes and reconnect it. After that, disconnect power to the appliance for 2 minutes and reconnect it.
Weak signal
Without a strong signal (full bars), move your router to a different location in your home, obtain a compatible signal extender, or contact your Internet Service Provider.
Related codes
FCE2 and FCE3 are router-connection codes worded the same way, while FCE7 says the appliance did not connect to your router.
Whirlpool microwave service in Los Angeles
If FCE1 returns after the router and power resets, call (310) 448-6692 for Whirlpool microwave service in Los Angeles. Have the code, the model number and the router steps you completed ready. Read about microwave repair too.
Stop immediately if you notice smoke, sparks, a burning smell, gas odor, or water near electrical parts.
Safe
Important
Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Whirlpool®
Seeing this codeon your appliance?
Book an Whirlpool appliance service visit for a clear estimate and approval before any repair.
Book
Experienced technicians, clear diagnostics, and workmanship coverage on completed repairs.
