Written by
Maya Ortiz Appliance Repair Content SpecialistPublished October 20, 2026
Whirlpool®
Code overviewat a glance.
The facts for this Whirlpool error, a plain-language snapshot, and what to confirm against your model number.
LF
Error codeLF
ApplianceWasher
Quick answer
LF, also shown as F8 E1, means a long fill. The manual points to the drain hose and the water supply.
Model note: Whirlpool reuses codes across series and model years, so LF may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Whirlpool®
What this codemay mean.
A plain-language reading of the code — always confirm against your model’s documentation.
Mean
The washer is taking too long to fill, which may point to a drain hose or water supply problem.
What LF means
On a Whirlpool top load washer, LF (long fill) or F8 E1 in the display means the washer is taking too long to fill. The manual says either code may indicate a problem with the water supply going to the washer.
Drain hose installation
The drain hose may extend more than 4.5 in. (114 mm) into the standpipe. Any of these hose issues can make the washer siphon, filling and draining at the same time, so it never reaches the expected level. The manual lists these checks:
Use the U-shaped drain hose form and attach the hose securely to the drainpipe or tub.
Keep only 4.5 in. (113 mm) of hose in the drainpipe.
Do not tape over the drain opening.
The minimum drainpipe height is 39 in. (99 cm).
Straighten any kink and remove any blockage from the drainpipe of the utility sink.
Water supply
Make sure both inlet hoses are connected and both the hot and cold water supplies are turned on. The washer has sensors for the water supply and needs water going to the water valve through both hoses. If it does not detect both, the control detects a problem with the water pressure sensor, the lid locks and the machine goes into pump-out mode for 8 minutes.
Related codes
Ld – long drain, the opposite problem of draining slowly.
If LF returns after the hose and supply checks, call (310) 448-6692 to arrange washer repair in Los Angeles. Have the code, your model number and notes on what you tried ready.
Stop immediately if you notice smoke, sparks, a burning smell, gas odor, or water near electrical parts.
Safe
Important
Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Whirlpool®
Seeing this codeon your appliance?
Book an Whirlpool appliance service visit for a clear estimate and approval before any repair.
Book
Experienced technicians, clear diagnostics, and workmanship coverage on completed repairs.
