Written by
Maya Ortiz Appliance Repair Content SpecialistPublished October 20, 2026
Whirlpool®
Code overviewat a glance.
The facts for this Whirlpool error, a plain-language snapshot, and what to confirm against your model number.
L2
Error codeL2
ApplianceDryer
Quick answer
L2 (low or no line voltage): a possible home power supply problem that keeps the dryer's heater off.
Model note: Whirlpool reuses codes across series and model years, so L2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Whirlpool®
What this codemay mean.
A plain-language reading of the code — always confirm against your model’s documentation.
Mean
Low or no line voltage; possible home power supply problem.
L2 stands for Low or No Line Voltage. It tells you the problem may be in the home power supply, and that the dryer’s heater is not able to turn on. The dryer keeps running with the code showing, and touching any pad clears it back to the estimated time remaining.
Where it applies
The code is listed for commercial-grade residential dryers, standard dryers and HybridCare dryers. On HybridCare models the manual calls it a diagnostic code and notes that it only shows during the initial installation.
What to check, in order
Check the household fuses or circuit breakers. An electric dryer uses two, one for the motor circuit and one for the heating element, and a tripped one can leave the dryer without heat. It needs a 30-amp circuit fused on both sides of the line.
Confirm the power cord is installed correctly, following the installation instructions. Unplug the dryer before you look at the terminal screws, and make sure they are tight.
Cycle the power: turn the breaker or breakers off for one minute, turn them on, start a Timed Dry heated cycle and watch for one minute to see whether the code returns.
Electric dryers need a 240-volt supply. If the message persists, have a qualified electrician verify the electrical supply.
Related codes
PF appears after a power failure interrupts the cycle.
hE is a heating error with temperature too low or too high.
Dryer service in Los Angeles
When the supply checks out and L2 still shows, we handle Whirlpool dryer calls in Los Angeles. Phone (310) 448-6692 with the code, your model number and the steps you have run, or read about Whirlpool Dryer service.
Stop immediately if you notice smoke, sparks, a burning smell, gas odor, or water near electrical parts.
Safe
Important
Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Whirlpool®
Seeing this codeon your appliance?
Book an Whirlpool appliance service visit for a clear estimate and approval before any repair.
Book
Experienced technicians, clear diagnostics, and workmanship coverage on completed repairs.
